Yugo buttstock

Post by **LtShaffer** » Thu Nov 02, 2006 4:40 am

How tight does your stock fit on your buffer? I know there is play, but mine won't go all the way on and lock. It will go on and lock with a 1/8" gap between the stock and bffer. I have tried it on my three other 42's with no problem. It's just this stock that won't work. Any ideas?

Post by **TOM R** » Thu Nov 02, 2006 10:58 am

if that is the case you have a german buffer and yugo stock or vise versa

Post by **hakentt** » Thu Nov 02, 2006 11:06 am

there should be no gap, you have a buffer from another stock. The matching part number kit that I got from angola fits stock very tight. You will need to fill in some weld to make it tight.

Post by **longhorn109** » Thu Nov 02, 2006 1:16 pm

TOM R is probably correct on this and I agree. Follow this link and scroll about half way down.

http://www.panzer46.net/mg42board/viewtopic.php?t=1688 .

It show what happens with different combinations of Yugo and German Stocks/buffers.

The stickies section its got LOADS of good info in it, have a look.

Post by **drooling idiot** » Thu Nov 02, 2006 4:16 pm

NO, don't do this

hakentt wrote: You will need to fill in some weld to make it tight.

shaffer i got a Yugo buffer with my last German kit with a German buttstock , possible swap on the buffer?

Post by **LtShaffer** » Fri Nov 03, 2006 5:30 am

I sent you a PM drool.

Post by **LtShaffer** » Mon Nov 06, 2006 5:05 am

Sent you another PM drool.

Post by **LtShaffer** » Fri Nov 10, 2006 9:00 pm

Sent you a buffer and another PM drool.