Hey all!! How you been?

[helix60]

As titled. Been away from here awhile, and thought I would stop in and say hello. Anybody making any progress on their 34's?

Regards,
Heli

[42rocker]

Welcome back. Myself I bought a mg34 mountain lafette, which made me buy a dummy receiver from brp so I could put my parts kit together to at least sit in the lafette. Also picked up a couple of cut up mg34 receivers at the last creek. Now thinking about building that reweld jig and trying to do a mg34 receiver reweld and going from there.

As the man asked anyone else doing anything new with mg34's? Next.

Welcome back again.

Later 42rocker

[www.Prussia.us]

Holy Smokes Heli,

Thought you ran off with the Gypsies, no seriously I hope things are doing better with you.

I am not going to talk all tough, my first '34 re-weld looked like a Bavraian pretzel, the second looked worse than Conrad Murphy's work, then I got smart. Between the nature of the ductile iron, trying to be cheap w/ filler parts, and not being the best tigger, I got it worked out-that is I outsourced it to Stan, and never looked back

Ironic I remember grubbing around for $450-$600 3-cut receiver sets when '34 kits were $499-$699, now '34 kits are over $1K and the IMA 2-cut receivers are less than $300, but good luck getting TNW to sell you the semi-grip conversions.

Any new and cool projects on your end?

[anjongni]

http://www.gunauction.com/buy/11748852/ ... ersion-kitThis is the TNW kit if anyone could use it....Phil

[DARIVS ARCHITECTVS]

Dood! Welcome back!