Yea I have been known to get people hooked on the Subguns ya know ya need to get one more Kit a Sten MKIII kit & check out www.indianapolisordnance.com the owner Jason is a buddy of mine he posted Pics of 2 of my guns on his site His products are Top Shelf stuff.
The stuff I used is called 'uni-strut',it is used in construction to hang pipes,wire conduit,lights,etc.It can be found in most plumbing or electric suppliers. ---bil
"I dream of a world where I can buy alcohol,tobacco and firearms from the same drive-up window,and use them all on the way home from work!" Dogbert
thank you sir im going monday to get some. FYI im done cleaning and prepping the shroud...fixing to weld up the threaded muzzle bushing...i will probably be sucking hind tit on that job too so i will no doubt need your help. I didnt quite understand the whole "indexing" part on the tutorial...thx bil
You MUST understand this before you do any welding up front!!This is one of the most important parts,get it wrong and you won't be able to get the barrel into the gun! There is also a tutorial on Pirates site about installing the wiselite repair part that explains it.Feel free to ask about anything you are not sure of. ---bil
"I dream of a world where I can buy alcohol,tobacco and firearms from the same drive-up window,and use them all on the way home from work!" Dogbert
I will look in the files for pictures-the tool and wacker are in Alaska right now,and I will be leaving for California in the morning! But within a few days I am sure we can get the info to you! ---bil
"I dream of a world where I can buy alcohol,tobacco and firearms from the same drive-up window,and use them all on the way home from work!" Dogbert
You did... but... it's like a train wreck! you can't NOT take a little peek. NOT STARE, just a lil' peek. Enough to make me wake up screaming every night for several years.
Due to a time warp,I finally found the pictures asked for ,I re-posted them in this thread,page 3.Bucking tools for the rail rivets.Happy Wacking Day!! ---bil
"I dream of a world where I can buy alcohol,tobacco and firearms from the same drive-up window,and use them all on the way home from work!" Dogbert
Bil wrote:I used the copper backer to get the tack welds started,then followed heli's advise and welded through,to get a stronger weld.I was careful and didn't let it build up too much inside.Here are some pics of the camming section welds.I would like to thank my friends at the bike shop for all the help,especially Stan,who cut short a very interesting evening at 7 am to open up and help out.The night had just begun!
i wont make airsoft replika can you send me plans of parts whit dimensions
---bil
---bil
