FS: German 42 receiver

[haseo8up]

German 42 receiver. Started out as a four cut all original pieces, grip opening is milled to not accept a full auto trigger housing. Also, a bolt block installed so no full auto bolt can be inserted. No rails are installed. This was once a working semi for my own use. Barrel Gate still has factory rivets in place. It still needs the cosmetic work before finishing. It was tig welded together. I'll state this again, it is a none working receiver, you will have to finish it to make it a semi auto. This is similar to what PDstout offered as a service.

I have to move this, all forum rules apply. Asking $700 US dollars shipped to you. If this does not sell, it will move to gunbroker and cut up again to sell as parts. First one to post here I'll take it, gets it. Any questions, please contact me through this site PM's.

[sdk1968]

would you happen to have a picture of the marking on the side?? or just the other side in general??

know someone looking for one of these if its an actual 42 instead of a 53..

[drooling idiot]

I'd put money on it being a 42.
Barrel gate having a screw not a rivet, and front AA mount indicate a 42 or very good imitation. I also don't believe any of the 53's were released as 4 cuts.

haseo8up, you should really think about using an FFL for the transfer. That looks like it might be a little too close to working to just hand it off.

[haseo8up]

Thanks DI, was kind of wondering myself. It is German receiver. It was a bad cut job near the left side markings, NC and MG 42 still intact, the others are not. I'll get pic's if still interested.

[www.Prussia.us]

I'll take it

[www.Prussia.us]

Haseo8up,

My PM box is not showing that my PM was sent to you (everything is getting jammed up in the outbox) anyway please let me know where and how to send payment.

Thanks,
Shaun

[haseo8up]

Fritz got to me first, prussia is next in line, then others

[FKpt.Fritz]

payment sent