MG3 feed tray question
Posted: Thu Mar 20, 2008 7:05 pm
Hi guys, I'm working on a CAD project building the MG3 feed tray for visual presentation and I need some help. Please take a look at the picture.
Marked with arrow #1 is the bracket of the belt hold lever. Arrow #2 is pointing at the welding on the front part of that bracket. It looks like the bracket bent up and welded on the side plate of the can mount, so the welding point looks like 2 plates thick. Arrow #3 is pointing at the rear part, where the bracket also bent up, but merged together with the bent down plate of feed tray, so at the welding point it looks like only 1 plate thick. It's very difficult for me to figure out how the bracket is welded, could anyone please help me?
Also I can't see how the belt hold lever is attached to the pin. Could anyone help me with some diagram or close up photos please?
Thanks in advance.
Marked with arrow #1 is the bracket of the belt hold lever. Arrow #2 is pointing at the welding on the front part of that bracket. It looks like the bracket bent up and welded on the side plate of the can mount, so the welding point looks like 2 plates thick. Arrow #3 is pointing at the rear part, where the bracket also bent up, but merged together with the bent down plate of feed tray, so at the welding point it looks like only 1 plate thick. It's very difficult for me to figure out how the bracket is welded, could anyone please help me?
Also I can't see how the belt hold lever is attached to the pin. Could anyone help me with some diagram or close up photos please?
Thanks in advance.