MG42 Barrel Dissassembly

Anything MG42 related.
Post Reply
Mikesal
Stabsunteroffizier
Stabsunteroffizier
Posts: 51
Joined: Sat Dec 20, 2008 7:59 pm

MG42 Barrel Dissassembly

Post by Mikesal »

What is the trick to remove the extension from the end of the barrel without destroying everything? I've experimented with an old de-milled barrel & can't get it to budge, using some heat and a big big pipe wrench. We've got some barrels I'd like to re-build as blank barrels & it would help to get the extension out of the way in order to make new barrel shafts.
thanks,
Mike Sal
anjongni
Oberstleutnant
Oberstleutnant
Posts: 420
Joined: Sun Jan 03, 2010 9:31 am
Anti-spam: Mg42

Re: MG42 Barrel Dissassembly

Post by anjongni »

"Kroil" works well for me.
Submergence in this stuff for a couple days, then the freezer, then the heat gun. Once the Kroil does its work, along with the temperature extremes, the parts will be as loose as they're ever gonna get.
Good luck!....Phil
User avatar
JBaum
Administrator
Administrator
Posts: 3149
Joined: Sat Mar 12, 2005 8:41 pm
Anti-spam: Mg42
Location: NE Ohio
Contact:

Re: MG42 Barrel Dissassembly

Post by JBaum »

clamp the barrel stub in a big vise (perhaps a pipe vise on a tripod), put a stout rod through the holes in the barrel extension and unscrew it. If necessary, you might try a thin grinder on the peened spot on the barrel stub to remove it to make it easier to get started.
John@German<remove this>Manuals.com

http://www.GermanManuals.com
42rocker
Administrator
Administrator
Posts: 3292
Joined: Fri Jan 11, 2008 6:03 pm
Anti-spam: Mg42
Location: Florida

Re: MG42 Barrel Dissassembly

Post by 42rocker »

I bring this OLD thread up as a lot of extensions with barrel stubs have come on the marketplace as of late. Also at least 2 venders are selling new barrels without extensions.

Later 42rocker
Hartek
Hauptgefreiter
Hauptgefreiter
Posts: 12
Joined: Wed Dec 13, 2023 9:47 pm
Anti-spam: Mg42
Location: Florida

Re: MG42 Barrel Dissassembly

Post by Hartek »

Is there a torque spec range when assembling and setting headspace?
User avatar
JBaum
Administrator
Administrator
Posts: 3149
Joined: Sat Mar 12, 2005 8:41 pm
Anti-spam: Mg42
Location: NE Ohio
Contact:

Re: MG42 Barrel Dissassembly

Post by JBaum »

Tight as you can get it without bending anything, then dimple the joint to keep it from unscrewing.

I guess you're looking for a foot-pounds spec: I never read anything specific about that in any of the repair manuals.
John@German<remove this>Manuals.com

http://www.GermanManuals.com
Post Reply