Page 1 of 1
MG53 RATCHET PLATE
Posted: Mon Aug 23, 2010 12:24 pm
by 1851NAVY
I'm currently building an MG53 semi auto and am lacking the full ratchet plate. Using a sketch and my existing parts I drafted this myself for the build community to use (and me). It's from a 53 - not a 42 but may work on them as well. I'm not sure what the milled slot is for on the back side but I included it - it's probably not necessary. It is full scale on an 8 1/2" x 11" sheet.
Re: MG53 RATCHET PLATE
Posted: Mon Aug 23, 2010 6:40 pm
by Bil
Thanks muchly! The slot is for the cocking handle to ride in! ---bil
Re: MG53 RATCHET PLATE
Posted: Tue Aug 24, 2010 2:03 pm
by 1851NAVY
Bill - that's good to know - now I will be sure to use the slot for alignment when I reweld it and keep the weld out of that area!
Re: MG53 RATCHET PLATE
Posted: Tue Aug 24, 2010 10:45 pm
by Bil
Yes-that is the main problem when rewelding the torched ones,you have to get it right,and it is very hard to get a dremel in there to do any trimming! ---bil
Re: MG53 RATCHET PLATE
Posted: Thu Aug 26, 2010 1:07 pm
by 1851NAVY
Good news - called Bryan at BRP and they were (are) back in stock!!! $50 - can't knock that! It's on the way!