Page 1 of 1
Measurement from recuperator hole to buttstock?
Posted: Mon Feb 11, 2008 2:06 am
by joew
I have a set of BRP halves, the only place I have to go from to measure is the forward recuperator hole. Would one of you guys be so kind as to give me the measurement from the rear wall of the forward recuperator hole to the end of the receiver so I can start cutting?
Thanks,
Joe
Re: Measurement needed
Posted: Mon Feb 11, 2008 8:14 pm
by longhorn109
I will have a play about later today and see if I can get the measurement for you. Not doing it now as it is 1AM and the other half will make shouty noises at me if I start taking guns apart now. I don't see the problem myself.
Re: Measurement needed
Posted: Tue Feb 12, 2008 8:52 am
by longhorn109
Just made a quick measurement on mine and I get 351mm
Re: Measurement needed
Posted: Tue Feb 12, 2008 4:09 pm
by longhorn109
Just to make sure we are all measuring the same points here is a pic of what I measured. I have left the image large so you can zoom in.
Re: Measurement needed
Posted: Wed Feb 13, 2008 12:46 am
by joew
Longhorn, that's it, thanks so much for your time.
Joe
Re: Measurement needed
Posted: Wed Feb 13, 2008 11:28 am
by longhorn109
Glad to be of help.