MG34 sear and trip installation

[c310pilot]

I have been looking for info on how to assemble all the parts and the prior post have broken links. Could someone please help out and send me some info please? Thanks!

[42rocker]

I don't know if this will help out... But here is a link

http://www.militaryphotos.net/forums/sh ... -friendly)

Just reviewed it and it might not help out with the detail that you need, for others check out the above link.

Later 42rocker

[c310pilot]

I should have been more clear. I am building a TNW based reweld semi. Where the trip is installed in the receiver it hits where the old spring mount for the sear is. Does this need to be cut out and raised? The half moon looking piece on the trip doesnt look like it can possibly hit the sear on the bolt? I am looking for more detail on these aspects of the build.

Here is the progress thus far:

[flemgunner]

I had to dremel a small amount off so the the half moon part would make contact. I also put a bead of weld on the sear ramp to raise it and make it a full ramp as opposed to the abrupt edge that they have on there now. I think I have a thread on it with pix, here or and weapons guild

[ChrisPCook]

Here's how I did mine, redid the entire area on a reweld to match TNW's design... Chris...
viewtopic.php?f=17&t=9380

[Intruder196]

Here's how I did mine, redid the entire area on a reweld to match TNW's design... Chris...
viewtopic.php?f=17&t=9380

Thank you for posting this. I had the exact same problem with my build. Your tutorial was a great help.

[largek9]

Thanks alot i will download!!!

[42rocker]

largek9
Welcome to the site. Enjoy the good Stuff.

Later 42rocker