www.MG42.us

I am starting my mg34 build and cannot find anything to reference the assembly of this gun. I am stumped by the semi trigger assembly. All I have is something from TNW that is very unclear. I called them but they said that they are not sure as to whether they can release that info event though I have TNW parts. If anyone has a TNW gun or any assembly instructions please share. All I need is a few pic and I can probably figure out the rest. I am also unsure about how the recuperator goes in. It protrudes past the barrel shroud when bottomed out. This can't be right. Did TNW not drill the hole deep enough or is there another reason?

I know that there are two different length recuperators, so you might want to check on that....you can trim back the thinner section in back to a shorter length, search the threads, there is a link with the difference on the length. Chris....

well here goes! the recuperator length is 5.11 inches, my instructions say if its longer than that trim to length, off the end where the spring goes on!!!! I hope this helps! my recuperator sticks out a little bit past the end of the reciever with roll pin in! later nauheim!

"cannot find anything to reference the assembly of this gun"

PM jbaum for his German translated manuals on the mg34... They should help out a lot.... I have his mg42 manuals and they are great....

Later 42rocker