Page 1 of 1
Adjusting trigger pull
Posted: Tue Jul 17, 2012 7:41 am
by rgus48
I have read that the TRW semi's have terrible trigger pull. I have had folks tell me that they cannot fire the weapon using a single finger and have to ues 2. Is there anything that can be done to aliviate this without running into issure with the ATF?
Re: Adjusting trigger pull
Posted: Tue Jul 17, 2012 3:20 pm
by anjongni
I use the original German f/p spring in mine, as do others here. The trigger pull is still more comfortable with two fingers, but much less stiff. I feel that the fire control parts will last longer too. If you set up like this, skip spaces in the belt until you're sure it fires only one at atime. I haven't had a problem. Good luck...Phil
Re: Adjusting trigger pull
Posted: Wed Jul 18, 2012 5:50 am
by rgus48
I will try that. Thanks Phil
Re: Adjusting trigger pull
Posted: Thu Jul 26, 2012 12:23 pm
by merc15
The orig firing pin trick works...but not with most surplus ammo. The surp ammo had the typical hard primers and i found that using orig springs does not have the strength to set them off. Firing blanks is a whole diff story as blanks use a soft primer and the orig spring works well with those.