I got real deal on the EDM Machine. Only it doesn't have enough Z height for an 80% receiver. I'm limited to 12 1/4 inches in height. The reciever is just under 13". Paying a shop to cut EDM is not cost effective to me. Since they have a minimum rate that must cover all expenses, labor, wire, electric, machine payments, maintenence, ect.... I paid cash for the Wire EDM I have, the deal was too good to pass on. I also got it for a number of other projects I have in mind in the near future. It seams there is not a shortage of magwells for the CZ 26/24 out there thanks to out fearless leaders. I will have a bunch of Maxim parts to make if I ever get an answer from tech. Spade kits for the Browning, ect....
Regards,
Heli