WTS: Lewman Arms MG42 welding jigs
Posted: Tue Sep 28, 2021 11:31 am
These are the absolute best MG42 welding jigs that have ever been available outside of a factory, hands down. The jig runs the entire length of the receiver forcing a straight line thru the center of the receiver. The jig interfaces with the bushing, the barrel stop, the rails, and the rear buffer sandwiching the receiver to the correct length. This is not a backing type jig that goes behind the metal to weld. There is still some clamping and tweaking of the metal needed, these have been widely torch cut and beating around in garages so its expected. We built a prototype jig 2 years ago and have been using it since and built over 100 guns on that single jig. These are professional, repeatable jigs that will last and last. Heat treated for longevity and black oxide finished for beauty. This jig will make your MG42 build MUCH easier by forcing the receiver into alignment and cutting way down on fitting time.
We need your name, address, and email PM'd to us so we can send you an invoice.
$1250 + $35 shipping coast to coast.
We need your name, address, and email PM'd to us so we can send you an invoice.
$1250 + $35 shipping coast to coast.