Page 1 of 2
Allegheny Aresenal receiver pictures
Posted: Tue Mar 01, 2005 11:18 am
by Stickerman
Posted: Wed Mar 09, 2005 3:37 pm
by TOM R
hey that looks like my kit, you bastard! give it back
I only need the piece in the first pic
Posted: Wed Mar 09, 2005 4:29 pm
by Guest
LOL, I will really make you mad.... I traded a couple of pieces for one of my flat bending jigs for the whole front piece! That saved about $75 or so for me. Plus I get to weld the front piece on with basically zero gap instead of a 1/4" one.
Then just yesterday the ratchet plate came in from brpguns.com Now they will all just sit and wait for me to get a chance to work on them.
Posted: Wed Mar 09, 2005 5:45 pm
by TOM R
gimmie gimmie or I'll kick you in the nutz
lucky bastard, also nice username guest
Cut 42
Posted: Wed Mar 09, 2005 5:55 pm
by Dan @ Angola Armory
Thats horrible, those cuts are VERY bad, those critical areas are impossible to rebuild, even for the most experianced welder.
Posted: Wed Mar 09, 2005 6:28 pm
by TOM R
the only good thing about this cut is that you get a complete straight barrel shroud, just need a bearing, dan got your email and sent one your way.
but no matter how you look at it from the trunion back it is trash.
Dan you found us
Posted: Wed Mar 09, 2005 6:43 pm
by 1919gunner
Glad to see ya here. Hope you can enlighten us with knowledge.
BTW where's my 2 recievers? I'm ready to build something.
See ya later ........ Shawn Woodruff
Posted: Wed Mar 09, 2005 10:18 pm
by Foobarr
Damn!
Looks like my 2-yr worked that over.
Posted: Fri Mar 11, 2005 4:30 pm
by Apatriot
That is the worst butcher job i have ever seen.
Nice
Posted: Thu Mar 17, 2005 10:06 pm
by Reichpapers
Nice of them to let the grinding wheel have a run of the receiver.
Posted: Sun Jun 26, 2005 9:45 pm
by Daskraut
repost the pics
Posted: Sun Jun 26, 2005 9:56 pm
by ak47dennis
Daskraut wrote:repost the pics
Its not for the weak stomach
Posted: Mon Jun 27, 2005 1:48 am
by Ron A
Can't see photos????
Posted: Mon Jun 27, 2005 7:30 am
by TOM R
they torch through the front bearing, through one of the rear buffer lugs destroyed the trunion area, the trunion got fd up with a grinder as did the rear rec when removin the rail rivets see the post drooling idiot tom r semi build and you'll see what i had to do to use this rec
Posted: Mon Jun 27, 2005 7:34 am
by TOM R
either we lost these pics or he hosted em somewhere and they expired
Posted: Thu Jun 30, 2005 8:16 pm
by ak47dennis
Here you go!!!
Posted: Thu Jun 30, 2005 8:18 pm
by ak47dennis
Had enough yet
Posted: Thu Jun 30, 2005 8:19 pm
by ak47dennis
Not sick yet!!!
Posted: Thu Jun 30, 2005 8:22 pm
by TOM R
wow I think yours is worse than mine if thats possible, where is the pic of the torched barrel bearing
Posted: Thu Jun 30, 2005 8:57 pm
by ak47dennis
The bearing was cut just didnt take a picture
