Page 1 of 1
reciever set up before weld
Posted: Tue Aug 09, 2005 9:46 pm
by jasond
:twisted: the trigger assembly on the mg 42 the front portoin is it suppose to slide all the way forward then lock down oh ya it full auto so its not mod. yet. and i have welded it yet im settin up to get welded. pictures would help alot
Posted: Tue Aug 09, 2005 11:14 pm
by salt6
Did you read this;
http://www.salt6.com/pirates%20build.htm
And I'd like to point out the first paragraph in the article!
Posted: Wed Aug 10, 2005 1:12 pm
by Karbinator
This has got to be a trick ATF question
Posted: Wed Aug 10, 2005 6:46 pm
by Pirate
Karbinator wrote:
This has got to be a trick ATF question
And the answer is, $25,000.00 fine and 25 years at club fed!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Posted: Wed Aug 10, 2005 7:20 pm
by DRH
I thought the NFA violation was $250,000.00 and/or 10 years in federal prison. Either way it is not something to take chances on. JasonD it was nice meeting you at Lucky#13's 1919 build party. Cut out the grip stick area and weld in a bolt block pin before doing any reconnections of the pieces, these simple mods should not take more than a hour or two and doing them first is very necessary.
oops
Posted: Fri Aug 12, 2005 8:58 pm
by jasond
oops i worded my question wrong .. the problem is that my kit is appears to be to kits combined so theres a ton of over lap but its cut in the stcik grip slot so i need to no how snugg it fitt before i do the welding then the semi mod.
Posted: Fri Aug 12, 2005 9:04 pm
by Pirate
There are a couple of receiver drawings with dimentions in one of the forums here. that should help.
You can also set the parts side by side and look for locator points to determine the length.
Posted: Fri Aug 12, 2005 9:57 pm
by TOM R
jason follow this link to the rear rec diagram hope this helps
http://www.salt6.com/MG42/Reciever%20print.jpg
if you got dial up it may take a while
