MG42 Unwelded Halves on BRP Guns
Posted: Tue Aug 09, 2005 1:14 pm
Would the unwelded MG42 receiver halves on BRP Guns be good for a semi build? Just wondering.
Page 1 of 1
Posted: Tue Aug 09, 2005 1:45 pm
I think its what tomR used
Posted: Tue Aug 09, 2005 2:09 pm
waste of time imho, instead buy the assembled rear rec from brp with racthet plate installed for $100, this is what i did and so far i got no problems and almost ready to shoot, btw it is also in semi config and they call it scrap for use on an oxy build or dummy 
Posted: Tue Aug 09, 2005 4:26 pm
Tom,
Aha, that's what you bought.
What differs on the inside of that rear half over the original?
'm just curious if they shortened up the belly side so a FA bolt
wouldn't work in it, or if there's a plug somewhere.
Aha, that's what you bought.
What differs on the inside of that rear half over the original?
'm just curious if they shortened up the belly side so a FA bolt
wouldn't work in it, or if there's a plug somewhere.
Posted: Tue Aug 09, 2005 4:35 pm
grip well is opened and thats all i see,l still need a bolt stop I think
Posted: Tue Aug 09, 2005 5:03 pm
What is wrong with them that BRP considers them to be unusable? I wonder if some are worse than others.
Posted: Tue Aug 09, 2005 5:11 pm
all I can think is cosmetic blems, maybe, if I get the recoup in i am done so ???
Posted: Tue Aug 09, 2005 9:40 pm
It would bite if they scrap'd those things cause the mill jumped when tapping out the holes...for say, the recuperator maybeTOM R wrote:all I can think is cosmetic blems, maybe, if I get the recoup in i am done so ???
....or the left rail
Posted: Tue Aug 09, 2005 9:49 pm
all holes line up, actually looks like it was assembled then disasembled even has a sn that is welded over