Barrel shroud to trunnion length??

[Daskraut]

I need the EXACT from the factory length from the end of the receiver to the trunnion window as seen in the pic, +/- .0005 if poss :P well, within 1/32....ish?. This is NOT shown on any print I can find. Thanks again.

[Daskraut]

I can not believe that nobody out there can measure there receiver for this info starved , stone mallet wielding wanna-be gunsmith!. Surely one of you has an uncut receiver?. I should be welding this week and REALLY need this dimension. Hell, just send your welded dimension and I will average them out!.

[TOM R]

these are from huntsinmtns oal 37.750 back of rec to trunion stop 15.5, left of trunion to booster end threads 21.4375, back of rear sight tobooster threads 20.875

hope this helps

[Daskraut]

leave it to Tom to once again save my bacon. By the way, cool pic of your guns in the house!, got wife?, mine just smiled and shook her head as she walked away.....but she did smile.

[TOM R]

no wife, close till she wigged out , liked the guns, is a shame we got along great for over 4 years, they have always been set up in the house but used to be in a spare room upstairs, I should find you a christmas pic

[Jason]

just measured mine and without removing the trunion it is 21 3/16"

[Daskraut]

Jason, is that dimension per my crude picture?. Tom, your dimension said "left of the trunion"....meaning you put a ruler from the end of the booster threads to the actual installed trunnion?. Feel free to draw a crude pic or mod one as I did. I will eventually draw up a print for this when all dims are confirmed.

[TOM R]

not quite sure, these are not my measurements these came from hunts as i wanted to be sure mine was ok before finish welding

[Jason]

daskraut, I measured from the very end of the reciever (end of the threads) to the front of the trunion 'window'.

I did not remove the trunion but I could see the front of the hole in the reciever and that is where I measured from.