www.MG42.us

Posted: **Mon Jan 02, 2006 10:23 pm**

Howdy All,
I have called BRP and I know he has the rivits, but I was wondering if anyone had them besides him. I know that they are 9mm by 75 or 80. He also suggested that you can use hardened bolts. Does anyone have any suppilers for these?

Thanks,
Big Mark

Posted: **Mon Jan 02, 2006 10:37 pm**

Yeah, this is a good question.

Posted: **Tue Jan 03, 2006 9:14 am**

http://www.robertrtg.com/mg.html

Robert RTG has trunnion rivets listed for $10

Posted: **Tue Jan 03, 2006 11:41 am**

I found a bolt that fit the trunnion hole, rounded the top to look like a rivet. You can drill out to .250 on drill press and use 8 grade bolt and nut if needed, or grade 5 and heat and peen over or use a rivet set for that size rivet. Good luck.

www.MG42.us

WTK Where to get Tronion Rivits

WTK Where to get Tronion Rivits