www.MG42.us

Hey Everyone:
I’m getting started on this build, perhaps too late (Story of my life), however I’m looking for a full rear section (80% I guess I need to say) that has the Receiver Rail dimples in it. It appears that now I’ve started to search...that either that detail was deleted from those selling them...or the Receiver halves are all but non-existant anymore. Can anyone enlighten me as to what is now available....or anyone who may wish to sell that which they no longer may need?

Regards,
Jack

Jack
I believe that most of the current receiver makers do not include those rivet dimples.
Anyone seen anyone making a receiver with them?

Later 42rocker

No dimples you can drill them yourself for cosmetics.

Use the BRP two piece shell. I think RTG has them in stock. Hope you can weld and mill.

Also the term 80% got axed by batf. Now using 70% and other fun terms.
Review the link that I sent you. The rebuild is lots of work. Might be better off to go the 3 cut yugo receiver route.

Later 42rocker