BOTH MG53S SHOT

[SHARPSSHOOTER5090]

I finally got a chance to shoot both the MG53s I built. After a little lubercation and cycling issures they both shot and feed great. Now all that's left is to remove the temporary rail machine screws, rivet them in place sandblast and put on a finish. I think I will Park them. SUCCESS FINALLY BIL!, YES I AM SHOUTING AGAIN!!!!!. Pictures when the finish is on them. I also was successful in shooting my BREN MKII I just built.

SHARPSSHOOTER5090

[aftershock2222]

Can you tell me what type of temporary rail screws you used and how you're giong to do the rivet job?

[SHARPSSHOOTER5090]

I used 10-23 socket head cap screws threaded into the rails and will use round head rivets to replace them.

Sharpsshooter5090

[Bil]

CONGRATULATIONS!! Glad to see you are almost ready-that is a good reason to SHOUT!! ---bil

[svt40]

I used 10-23 socket head cap screws threaded into the rails and will use round head rivets to replace them.

Sharpsshooter5090

You meant 10-32?

[12thWaffenSS]

You mean Ruger 10-22?

[www.Prussia.us]

As Mr. Burns would say, "Excellent."

Great work and you managed to get them done while there still is "Kaiserwetter" instead of freezing in the snow at the range

[SHARPSSHOOTER5090]

Yes, I ment 10-32UNF socket head cap screw. Sorry for the typo. I will post some pictures of them tonight.

SS

[SHARPSSHOOTER5090]

Here is some pictures of my MG53s, a BREN, my MG47 prototype, my MG47ES prototype, a 300WSM FAL, a standard 7.62 FAL and a 45ACP MAC-10.

SS

[Bil]

Man,I love those specialty guns you make-I wish I had that kind of talent! ---bil