use die grinder to remove rail rivets?

[aftershock2222]

Hi,everyone,I'm trying to use a die grinder to remove the rail rivets,but the bit just bounces off.What kind of bit do I use.Where do I get it?

[Jason]

when I removed the rivets from the rail I just took the dremel with the fiber disk and ground the rivet almost flush and then tapped them out with a punch. last night I was removing rivets from an ak and did the above but also had to drill out the center of the rivets first. start with a small bit and drill exactly in the center, then increase the bit size until the rivet spins out. either method should work depending on how stubborn the rivets are.

[ak47dennis]

I used a 3/16 4 flute cutter in a mill, this will prevent damaging the receiver and having to try and drill them out a potentially egging out the holes.