www.MG42.us

did you have to modify the bushing to get the right bushing depth or did you just put the bushing in until the angled parts mated up? this is were im at right now but my measurements are a little off if i just put it in until the bushing angles mates up.

where are you in cali?

Well I got the receiver welded up and got the buffer to turn pretty easy. The buffer area turned out to be a little bit of a chore. After some internal grinding and hammering the receiver to get it where it needed to be, I'm set for the next stage. I'll post pics when I get further along.

Has anyone experimented with a hk33 trigger pack in the original grip stick housing?

Mechwarrior if you could post pics I would greatly appreciate it.

Ok I got my receiver tacked together and it looks like I will have to take some material off the buffer for it to turn. Is this pretty standard? My receiver is about 4thousanths skinny that's the closest I could get it to the 2.200.

that last one does help thanks..

instead of sarting a new thread i will just ask on this one. on the brp rear section i know mateial has to be taken off to end up with the correct width but what about the length? after looking at all blueprints i haven't seen any measurements from the rear to a specific stamping point or bend.

if your missing any parts just call them up and they should send them out to you. i got a kit a few weeks ago and it was missing a bolt, after a call to cfs they sent it out.