www.MG42.us

welds to the bottom of the bolt to help push down/ cock the hammer, the little wing I believe gets bent over to act as cocking piece for the charging handle to grab on to.

Nice work, careful when welding in that blocker. Poured to much heat into mne and receiver pulled together in that area. Had to slit, space and reweld. Nice work!!

Johnnymg

http://www.frfrogspad.com/zeroing.htm


try this page it explains and has the formula

Johnnymg

yeah!!!!!!!!

Also the sanding disks in the angle die grinder do wonders, if you use the flap ones be very careful as those remove material very fast johnnymg Vey nice work, I used a flat file and dressed down the camming section area welds to get the camming piece to fit. Those little scotch brite disks in an an...

Vey nice work, I used a flat file and dressed down the camming section area welds to get the camming piece to fit. Those little scotch brite disks in an angle die grinder do wonders for removing finishes and polishing metal.

Johnnymg

Donation made, blocker received today, Thanks Oakrodent

johnnymg wrote:

oakrodent wrote:Johnnymg,
PM me with your info. I have one for you.

PM sent

Johnnymg

where these coming out of. Czeck republic or Poland?
A lot of bogus stuff being/trying to be sold from there

oakrodent wrote:Johnnymg,
PM me with your info. I have one for you.

PM sent

Johnnymg

saw a couple on GB

oakrodent wrote:I might have an extra BRP block for you. Will let you know in the AM

Thank You,

Johnnymg

Whats approved? and what are people using? Have posted a want add for BRP as the are closed for a couple weeks, Anybody have picks and dimentions of what they have used in their builds?
Thanks

Johnnymg

Anybody have one they can spare for a few weeks? BRP is closed for a couple weeks starting today till the 29th. Cannot order one for two weeks.

Johnnymg

Or maybe Ohio type?

Anyone have a measurement for placement of the front bushing? I know the overall measurement from doing a search, however was wondering if someone had a measurement from front site mount, bipod stamped area or from the camming piece to locate the bushing without a completed receiver to use the overa...

PortHolio, if you are not going to use the BRP blocker I would like to purchase it from you if you do not use it. Johnnymg looking for suggestions on the best or easiest method for blocking the full auto bolts. I'm building a BRP kit, and it came with a pretty elaborately machined "blocker bar". It ...

Fill with weld, TIG or MIG and use an end mill to "depress the area again to simulate?

Johnnymg

On a quality safe exterior hinges do not matter. HINGES SHOULD NOT BE A MEANS OF SECURING THE DOOR. most good safes use a lip that secures the back side of the hinge side of the door or better yet locking bolts that secure the door on all four sides. Heavier the better with the safe. If it takes fou...

Where you putting the safe? Mine is in the basement therefor granite finish, a friend from work, his is in his bedroom, hi polish/gloss paint job. $1000-1500 should get a nice size safe, check around get a solid well made one, stay away from the $300 specials that are not heavy, Mine unloaded is ove...

how about welding a 4 rib up some, and just re-cutting the smaller 5th rib??

Just a thought

johnnymg