Apex M53 parts kits
-
- Friendly New Guy
- Posts: 1
- Joined: Mon Sep 08, 2014 1:48 am
- Anti-spam: Mg42
- Location: concord CA
Apex M53 parts kits
I was wondering, what are the thoughts on the current batch of M53 parts kits from Apex? I am looking into ordering a kit along with BRP stampings to start an MG53/ MG3 Build. After seeing how the front barrel shrouds are cut by the ATF, would it be recommended to get the new MG3 Front sight/ barrel bushing piece and graft it into the shroud as supplied from Apex?
Re: Apex M53 parts kits
Here is my Build from an APEX kit I bought two years ago. After a lot of work I finally went with the full BRP receiver. Still it was a lot of work as I only have hand tools, Dremel, Drill press and a Tig welder.
- www.Prussia.us
- General
- Posts: 1060
- Joined: Sun Jan 06, 2008 7:17 pm
Re: Apex M53 parts kits
Nice work with the build 'USMC 8488"
"CessnaPilot89" you should pick one up, the prices will not likely be that good again, granted they have fluctuated over the years for the M53 kits, but at this juncture, unless lucky in the classifieds, you will not find a better deal.
"CessnaPilot89" you should pick one up, the prices will not likely be that good again, granted they have fluctuated over the years for the M53 kits, but at this juncture, unless lucky in the classifieds, you will not find a better deal.
“… corporations have been enthroned, and an era of corruption in high places will follow, … until all wealth is aggregated in a few hands and the Republic is destroyed.”
- Abraham Lincoln (Republican), Nov. 21, 1864
- Abraham Lincoln (Republican), Nov. 21, 1864
Re: Apex M53 parts kits
I agree with prussia, pick at least one up. Ie you want a shooter then buy 2 kits. I did and used the best parts and sold off most of the excess parts. there were some bad parts in both kits, remember they are used and some 50 to 60+ years old.
-
- Administrator
- Posts: 3251
- Joined: Fri Jan 11, 2008 6:03 pm
- Anti-spam: Mg42
- Location: Florida
Re: Apex M53 parts kits
usmc8488 -- Good Job on your build
The apex mg42 parts kit is a good parts deal. Then you might also want to think about getting a complete receiver (cut of course) from Allegheny Arsenal
http://mg34.com/
Later 42rocker
The apex mg42 parts kit is a good parts deal. Then you might also want to think about getting a complete receiver (cut of course) from Allegheny Arsenal
http://mg34.com/
Later 42rocker