JBaum wrote:Certainly not trying to rain on your parade, but:
Are you talking barrels with or without the barrel extension? If without, then they will need set up and the chamber reamed or the barrel spaced or trimmed to get proper headspace.
There's a lot of work to make a fireable barrel. Getting a barrel the right length with the correct threads on the end is only half the battle for an MG42/M53.
Is anyone still selling barrel stubs with the extensions?
JBaum wrote:The barrel itself is only 1/3 of the headspace variable. The other two are the barrel extension, and the bolt. All three need to fit together properly to get the headspace, but the barrel and barrel extension are the two that are able to be adjusted (chamber depth, and how far the barrel is screwed into the extension).
Since not every bolt someone pulls out of a pile will be within tolerances, headspace is checked with both the assembled barrel and extension, together with the bolt. Each may be off by a little, but together, they may not be outside the tolerance range (stacking tolerances). 10 or 15 thousandths can make a difference in whether the bolt rollers fully lock or not.
So, checking the headspace on the combination of your bolt and a new barrel is still required, just as it is with original barrels. The original guns came with 2 spare barrels (3 total), which were serial numbered to the gun for this reason. I still have one original barrel, serial numbered to the gun, for my MG42. The original bolts are long gone, so I still have to check headspace on each combination of the 4 bolts and 8 barrels I have.
If the manufacturer is capable of putting on the extensions and setting the headspace properly, that would be the way to go. Someone would be a fool to think that doing the extra work himself to make a bare barrel into something usable would be a good way to save $40 or $50.
If I were in need, I'd willingly spend $300 for a new barrel, properly headspaced, that's ready to be used.
Users browsing this forum: No registered users and 6 guests