• MG34 Receiver Basic Dimensions
Page 1 of 1

MG34 Receiver Basic Dimensions

Posted: Sun May 03, 2009 1:37 am
by 762x51
Here is a drawing showing the major dimensions needed for re-welds.
All NFA rules apply.

You can see the full size drawing here: http://www.autochart.com/MG34/MG34RecBasicDim.jpg

Image

Re: MG34 Receiver Basic Dimensions

Posted: Sun May 03, 2009 10:20 pm
by rocco1911
Thank you for posting this ... :wnana:

Re: MG34 Receiver Basic Dimensions

Posted: Sun May 03, 2009 11:08 pm
by Bil
Yes,thanks,Orin.I tried to do this once and made a mess of it. :( It will be handy when I try to figure out if I have enough material for a receiver. ---bil

Re: MG34 Receiver Basic Dimensions

Posted: Mon May 04, 2009 8:21 am
by 762x51
Glad to help guys. Let me know if you need any other dimension.

Orin

Image

Re: MG34 Receiver Basic Dimensions

Posted: Mon May 04, 2009 10:59 am
by 42rocker
As said before MANY THANKS for posting this...

Sorry that I missed out on your mg42 receiver cut sale....

Thanks Later 42rocker

Re: MG34 Receiver Basic Dimensions

Posted: Tue Dec 27, 2011 4:22 pm
by crash520
Thanks 762x51 for posting the good info

Does anyone know if any 34 rec ordnance drawings exist for all the dims of the 34 rec to scratch build one???

C

Re: MG34 Receiver Basic Dimensions

Posted: Tue Dec 27, 2011 5:29 pm
by 42rocker
There has been several good posts on this website about making one. However that said take a good look at the following website

http://www.tnwfirearms.com/photos.shtml

Note the equipment that they use to make the receivers. There has been talk about edm equipment and other things being used. I wish you a lot of luck.

Lots of folks buy several mg34 cut receivers and re-weld them...

Later 42rocker

Re: MG34 Receiver Basic Dimensions

Posted: Fri Dec 30, 2011 3:48 pm
by Bil
for prints,try Maschinengewehr34.com Glenn Fahrquhar He sold some sets here,









i have one somewhere,but as mentioned above,the expensive machinery used would keep most from going the avenue. ---bil

Re: MG34 Receiver Basic Dimensions

Posted: Fri Dec 30, 2011 7:10 pm
by 42rocker
The set of prints that Fahrquhar put out are nice ones. Think long and hard before you think of starting to make a mg34 receiver from scratch. That said it's been done by several countries and at least one company.

Later 42rocker

Re: MG34 Receiver Basic Dimensions

Posted: Thu May 10, 2018 12:17 pm
by toolmanm203
Does anyone have the front end blue prints for the cam location and rivet holes? Thanks.

Re: MG34 Receiver Basic Dimensions

Posted: Fri May 11, 2018 7:01 am
by Abominog
Interesting. As far as i can read blueprints this info is NOT in the J&G/ Farquist prints.

Would it not be in the TNW semi package?