• Camming cut outs in receiver
Page 1 of 1

Camming cut outs in receiver

Posted: Sun Nov 19, 2017 8:48 pm
by NickD
Hello,
I would appreciate any help with a diagram, measurements, photos of when the camming section cutouts have to be. I have a cold steel sol. receiver I need to weld to my front half of the receiver, and I want to know where the camming cutouts on the side need to be so I know where to cut off the excess metal from the Cold Steel receiver and where to make the cutouts. Thank you in advance.
20171119_174706[1].jpg

Re: Camming cut outs in receiver

Posted: Mon Nov 20, 2017 11:49 pm
by 42rocker
NickD
I wish you the best of luck with the cold steel receiver. Not to many folks have been able to get that one up and running.
There is a lot of info on this site, use your search button.
That said someone has gone above the call of duty, Brian at brp and post lots of great info. Check it out.

http://www.brpguns.com/mg42-semi-receiver-parts/

Good Luck again.

Later 42rocker