Camming cut outs in receiver

The #1 place for MG42 answers.
User avatar
Posts: 30
Joined: Fri Aug 11, 2017 2:38 pm
Anti-spam: Mg42

Camming cut outs in receiver

Postby NickD » Sun Nov 19, 2017 8:48 pm

I would appreciate any help with a diagram, measurements, photos of when the camming section cutouts have to be. I have a cold steel sol. receiver I need to weld to my front half of the receiver, and I want to know where the camming cutouts on the side need to be so I know where to cut off the excess metal from the Cold Steel receiver and where to make the cutouts. Thank you in advance.

Posts: 3199
Joined: Fri Jan 11, 2008 6:03 pm
Anti-spam: Mg42
Location: Florida

Re: Camming cut outs in receiver

Postby 42rocker » Mon Nov 20, 2017 11:49 pm

I wish you the best of luck with the cold steel receiver. Not to many folks have been able to get that one up and running.
There is a lot of info on this site, use your search button.
That said someone has gone above the call of duty, Brian at brp and post lots of great info. Check it out.

Good Luck again.

Later 42rocker

  • Similar Topics
    Last post

Return to “MG42 Stickies Section”

Who is online

Users browsing this forum: No registered users and 1 guest