Reichpapers wrote:Producing new semi autos is a rough business. Imagine trying to get a semi MP40 design approved and they deny it at the level where you sent a sample in. They wouldn't give it back to you.
Blademaster wrote:The BRP MG 42 has two blocks installed into the receiver (To prevent the installation of the orginal FA bolt). Are two needed? I am not sure why there are two I would think that one would be enough. Does anyone have any input on this? I know the early units only had rivets then later the blocks were being put in instead. I am now in the process of my own build and want to make some improvements. I am also thinking about installing some small brackets on the front area where the gripstick goes and putting either screws or a push pin for a rock solid grip stick. This is one of the improvements I am thinking about. Anyone have any input on this?
Users browsing this forum: No registered users and 2 guests