I just registered with this forum. I purchased a used TNW MG34 last year on GB. I just received a set of repro grip panels from IMA to replace the very worn and chipped original bakelite ones. Before I start, how do I do it? The replacement grips have new rivets. Thanks in advance.
I know this is an ancient post, but if you try to slide your grips up you will never get them off. Post should have said if your holding the pistol grip UPSIDE DOWN you slide them up, otherwise slide them down .
The views and comments posted in these forums are personal and do not necessarily represent the those of the Management of MG42.US.
The Management of MG42.US does not, under any circumstances, accept any responsibility for any advice or recommendations, made by, or implied by, any member or guest of MG42.US that results in any loss, in any manner to a member, or to any other person.
Furthermore, the Management of MG42.US is not responsible for the content of any other Internet site(s) that have been linked to from MG42.US.