Single Cut M53/MG42 Kit for sale

Got something to sell? Click Here. (A photo or a link is required!)
Forum rules
You MUST have five (5) posts elsewhere in the forums before posting here.

ALL POSTS MUST COMPLY WITH THESE RULES OR THEY WILL BE DELETED WITHOUT WARNING!

WE ARE NOT AN AUCTION SITE

F/S Posts must contain;

1) Your contact information .

2) A picture or a URL to a picture of the item for sale.

3) Or a link to who or where the item you saw for sale can be found. Links to auction sites are acceptable .

4) A fixed price (with or without shipping)(see 4a - 4c)
...a) stated in either ... gold,silver, U.S. paper currency, etc
...b) specific items your looking for in trade
...c) for cash+barter combos a fixed value for your F/S item is STILL REQUIRED.

If you find an item cheaper than a sellers stated price available somewhere else, PM or E-mail the seller. Give them the chance to evaluate adjusting their price, then if you still think the stated price is too high start a new thread in our deals section. Please do not hijack their ad ;)

Please remember...................

Let us know when all items are "SOLD" or "SOLD PENDING FUNDS". We will then move the thread to the Sold section when the sale is completed or after 90 days.
Post Reply
RetiredBuilder
Gefreiter
Gefreiter
Posts: 16
Joined: Thu May 12, 2016 2:20 am
Anti-spam: Mg42
Location: South Dakota

Single Cut M53/MG42 Kit for sale

Post by RetiredBuilder »

Image

Hello, I bought this kit off gunbroker a few months ago but have decided to go a different direction with my build. This kit is complete except for a barrel as far as I can tell all other parts are there. Still covered in cosmoline, there is bits of paper stuck to some parts, should all clean up very nicely. I have a bunch of pictures on a google drive to many to upload here, message me for the link.

Price is 2,500 plus 40 for shipping.

Notes on Demil Process for builders
1) Sinlge cut was made through the section where the camminig piece goes so the rails are still intact and the cuts were made in front of the recouperator leaving it still intact.
2) This is not a reweld. This will make an excellent build due to the front bushing having never been cut and the rear half of the receiver untouched.

Photo attached below, I dont think my rehost worked.
Attachments
20180508_193222.jpg
Blanksguy
General
General
Posts: 1434
Joined: Fri Jan 14, 2005 10:33 am
Location: Bay City, Michigan

Re: Single Cut M53/MG42 Kit for sale

Post by Blanksguy »

PM sent requesting "link", and questions.

Regards, RichardS
US Army, RET
Blanksguy2001@outlook.com
Post Reply