Need help fixing bbl bushing& nose PLEASE!
Posted: Sun Sep 09, 2007 10:46 pm
I welded up my receiver myself using my HF welder. All went well except I really boogered up the nose section. I cut a 2x2 section of the nose (L side) from my yugo kit and gave it too a buddy to cut and repair with his MIG setup. I got it back today and the bbl is binding so bad that I cant fix it. Ive tried a dozen times, (cut, weld, cut) but I really think the last 2 inches of the shroud need to be replaced. (its all welded and ground and welded and ground etc...) Is there anybody out there that can save this thing? Guys Im 10 minutes from giving up on this thing.........
FYI....Its now a full receiver. BBL block has been installed and trgr housing ground, but its considered 100% by ATF. AT this point I guess any work via postal transport has to be by an FFL?
Im ready to throw in the towel...........
FYI....Its now a full receiver. BBL block has been installed and trgr housing ground, but its considered 100% by ATF. AT this point I guess any work via postal transport has to be by an FFL?
Im ready to throw in the towel...........