• Hammer follow - Page 3
Page 3 of 3

Re: Hammer follow

Posted: Sun Jul 29, 2018 7:45 am
by robertmcw
Can you use a Dremel to grind the spring so it will look like this one?

https://www.gunbroker.com/item/771136785

RM

Re: Hammer follow

Posted: Sun Jul 29, 2018 11:29 am
by mtnlvr
That's a significant taper! Not that I've seen a lot of semi converted MG42's, but mine doesn't have that much length ahead of the spring. I suppose I could reduce the diameter a little, but I'd rather leave it original if possible. And is that end piece of my buffer thru hard or case hard?

I think I'll try to find a way to tighten the fit of the buffer to receiver first.

Here's mine.
20180729_100614~01.jpg

Re: Hammer follow

Posted: Sun Jul 29, 2018 12:17 pm
by robertmcw
That looks it is an Austrian part and the Yugo buffer will not fit with the stock. You can get a German buffer from RTG and that would fit. You can get them new and used so it would not break the bank and that way would not need to shim anything to see if that would solve the issue.

Re: Hammer follow

Posted: Sun Jul 29, 2018 6:18 pm
by mtnlvr
That is a Steyr butt stock.

Pardon my lack of knowledge, but what marking is this on the buffer? Is that a Yugo mark?

20180729_160211.jpg


If so, what do you mean that the Yugo buffer won't fit the stock? It assembles just fine.

I have two other buffer and butts in various parts kits laying around. This pictured buffer is the only one that the green Steyr butt fits on.

Re: Hammer follow

Posted: Sun Jul 29, 2018 6:36 pm
by robertmcw
This is all I know about buffers:

viewtopic.php?f=39&t=1688

RM

Re: Hammer follow

Posted: Sun Jul 29, 2018 7:33 pm
by robertmcw
And it looks to be a German WII buffer with the eagle and the WAA stamp but cannot make out the number. That is why it fits to the green stock.
RM

Re: Hammer follow

Posted: Tue Jul 31, 2018 9:20 am
by mtnlvr
The damn stickies! I read through them a few years ago but had forgotten all about them. Thanks for the reminder...very helpful.

According to the sticky, the other two buffers don't have the groove cut near the threads like the German buffer one I posted above does. The German one also has a bit larger diameter nose cap at 0.902", the other two assumed Yugo buffers are at 0.883". I was able to fit one of the two Yugos into the receiver and there was absolutely no bind on the bolt extension.

Tapering the nose cap would definitely rid of the bind. As would a buffer with a smaller nose cap.

Re: Hammer follow

Posted: Thu Aug 02, 2018 11:43 pm
by robertmcw
Can you swap the nose parts to the German one?