Disassembly of wood yugo buttstock components?

[HKARAK]

Need to separate the metal "cup" from the wood buttstock for a project. How best to do this? Does the push button unscrew, then the nut at base of cup to release the wood stock bolt? Thanks.

[JBaum]

There's a flat washer inside the metal cup on the push button nut. Flatten it so that the nut and screw can be separated (unscrewed). Then unscrew the main screw from the rear of the stock. The metal will pull out of the wood then.

[Der Alder]

The metal on the retainer is soft sheet metal. You can use a flat screw driver to get in there and pry it outwards enough so the nut can spin. Once you get it back together you can then bend the retainer back so the nut can't spin again.

[42rocker]

Here is a pic of everything taken apart. Ok, almost but the pic shows the insides. Only pic I had on hand.

Later 42rocker

[HKARAK]

Success! Thanks all for the instruction and photo!! One step closer to buiding spade grip :-)