Made my own receiver, designed so you don't have to cut a slot for the charging handle, instead it rides in a channel. The bolt blocker, a tapped and...
Still experimenting, but you'll get the idea, I'm going to weld this one up into a dummy receiver, so I'm just going to use 1/2 (I think that was the...
I have a torch cut receiver that I'll weld together. But before doing that, when I try to attach the front part of the receiver to the barrel shroud,...
I installed everything today and found that when the trigger bar pushes down on the sear, it just barely moves it. The sear depresses, but not enough...
My 2nd mg 34 will not eject, the bolt moves free everything is free moving, it seems the TNW spring in the bolt is too tight to allow it to come out...
My sear ring broke and took out my sear so i called TNW and they where great about giving me a new one but now both pieces appear to be hard and the...
the recuperator spring sags under the weight of the gun about 1/8 inch and is very slow to return the barrel when depressd, would this cause failure...
I have done the bolt and the trigger semi mods but dont understand what the rest of the parts in the TNW semi mod small parts kit are for,i am useing...
My receiver reweld is almost done. The blueprints that I purchased have information about heat treating and hardness...my question is....Do I have to...
Can somebody tell me how to remove the rear sight assembly from the barrel housing? Once the locking pin located on the barrel housing just under the...
I have to remove the front sight stem and the cone catch from the front sight base/booster sleeve and would appreciate information about the easiest...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum