Search found 2 matches

Go to advanced search

by jeffdai1992
Wed Jun 13, 2018 3:47 pm
Forum: MG42 Build It Yourself
Topic: Looking for help with the global machining receiver sections
Replies: 2
Views: 233

Re: Looking for help with the global machining receiver sections

I just got the number from someone who has done it before, the excessive length at the rear of a global machining repair section is 0.619 inch. This should be measured from the center channel where 2 halves joins (since the rear may not be perfectly square). With this number I can now mark everythin...
by jeffdai1992
Wed Jun 13, 2018 1:33 am
Forum: MG42 Build It Yourself
Topic: Looking for help with the global machining receiver sections
Replies: 2
Views: 233

Looking for help with the global machining receiver sections

Hi everyone, I am a new member to this forum. I have read through a lot of the posts here about building the semi-auto MG42/M53, but I still didn't find the info to help with my specific situation. I have a M53 kit with everything and a set of "repair sections" from global machining (I kno...

Go to advanced search



cron