Search found 4 matches

Go to advanced search

by Opie7afe
Mon Jun 18, 2018 7:41 pm
Forum: MG42 Build It Yourself
Topic: Looking for help with the global machining receiver sections
Replies: 2
Views: 146

Re: Looking for help with the global machining receiver sections

That's the problem I had, but since I was splicing in a m53 rear section I lined up the long cut shroud with the shells to where the profiles matched then measured from rear of cam window to rear of receiver which was 382mm if I remember correctly. From there I lined up the rear section untill the m...
by Opie7afe
Tue May 22, 2018 7:42 pm
Forum: MG42 Build It Yourself
Topic: Having an issue with gmt shells and m53 rear end
Replies: 0
Views: 147

Having an issue with gmt shells and m53 rear end

I'll start this out by saying I'm not bashing gmt.they are good shells just not lining up how I need them..would be perfect if I was doing the buffer cuts and tabs which I'm not. I have the receiver in spec to width of the rear section which is 2.196. any ideas on what to do regarding the difference...
by Opie7afe
Sat Mar 10, 2018 9:09 pm
Forum: MG42 Build It Yourself
Topic: Needing dimensions of a bolt blocker.
Replies: 0
Views: 370

Needing dimensions of a bolt blocker.

Since I'm waiting on some semi parts I need to think of the bolt blocker. Want to make it close to the brp one as I have the material and will be a good project for my new mill I know width of the bottom of the bar, I know height but I need the rest of the dimensions for the blocker. Can anyone help...
by Opie7afe
Sat Mar 10, 2018 9:06 pm
Forum: Chatter
Topic: Introductions (or one way to increase your post count).
Replies: 303
Views: 70066

Re: Introductions (or one way to increase your post count).

Another newbie has joined here..built other stuff always wanted a belt fed so here I am...thanks for all the knowledge that is here.

Go to advanced search